Altera DisplayPort MegaCore Function Manuale Utente Pagina 78

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 195
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 77
Bitec DP Card Signal Bitec Card I/
O
Description
HSMC Connector J4A
HSMA_RX_P[3..0], HSMA_RX_N[3..0] Output
RX Main Link lane[3..0] differential signals.
The demonstration software sets the RX Main Link
redriver’s EQ settings. Refer to main.c provided in
the demonstration software directory.
Depending on the channel condition, you may want
to try various combinations of the EQ, VOD/pre-
emphasis settings to achieve optimal link perform‐
ance.
I
2
C address for RX Main Link redriver: write=0×58,
read=0×59.
SCL_CTL, SDA_CTL I/O I
2
C bus signals to configure the TX and RX Main
Link redriver EQ, VOD/pre-emphasis settings.
TDO_TDI Not used
HSMC Connector J4B
RX_CAD Input
Cable Adapter Detect.
This is used to select DisplayPort mode or TMDS
mode in the Main Link redrivers.
0=DP mode, 1=TMDS mode.
The demonstration design selects the DisplayPort
mode(RX_CAD=0).
RX_SENSE_P Output
The sink uses this to detect the presence of the
source device.
0=Source DisplayPort cable is plugged.
1=Source DisplayPort cable is not plugged.
When connecting this to the sink rx_cable_detect
(active high) input, inverted signal should be used.
In the demonstration design, the rx_cable_detect
input is set to 1 in the RTL.
UG-01131
2015.05.04
Required Hardware
6-17
DisplayPort IP Core Hardware Demonstration
Altera Corporation
Send Feedback
Vedere la pagina 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 194 195

Commenti su questo manuale

Nessun commento