Altera DisplayPort MegaCore Function Manuale Utente Pagina 122

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 195
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 121
DisplayPort Source Register Map and DPCD
Locations
9
2015.05.04
UG-01131
Subscribe
Send Feedback
DisplayPort source instantiations require an embedded controller (Nios II processor or another
controller) to act as the policy maker.
Table 9–1 describes the notation used to describe the registers.
Table 9-1: Notation
Shorthand Definition
RW Read/write
RO Read only
WO Write only
CRO Clear on read or write, read only
CWO Clear on read or write, write only
Source General Registers
This section describes the general registers.
DPTX_TX_CONTROL
The IRQ is asserted when AUX_IRQ_EN = 1 and in register DPTX_AUX_CONTROL flag MSG_READY = 1. IRQ is
de-asserted by setting AUX_IRQ_EN to 0 or reading from DPTX_AUX_COMMAND. IRQ is also asserted if
HPD_IRQ_EN = 1 and a new HPD event is detected (HPD_EVENT in register DPTX_TX_STATUS different from
00). IRQ is de-asserted by setting HPD_IRQ_EN to 0 or reading from DPTX_TX_STATUS.
The TX_LINK_RATE drives the respective tx_reconfig port. Setting LANE_COUNT to 00000 causes the
transmitter GXB to always send a logical zero (i.e., a constant voltage level). You can use this function to
cause a “power down” for link layer compliance testing.
Address: 0x0000
Direction: RW
©
2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at www.altera.com/common/legal.html. Altera warrants performance
of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,
product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device
specifications before relying on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
www.altera.com
101 Innovation Drive, San Jose, CA 95134
Vedere la pagina 121
1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 194 195

Commenti su questo manuale

Nessun commento