
DescriptionLegal ValuesDefault
Value
Parameter
When On, the interface includes a writeresponse pin.On/OffOffUse the write response
signals
When On, the interface includes a readresponse pin.On/OffOffUse the read response
signals
When On, the interface includes a clken pin.On/OffOffUse the clken signals
Port Polarity
When On, reset is asserted high.On/OffOnAssert reset high
When On, waitrequest is asserted high.On/OffOnAssert waitrequest high
When On, read is asserted high.On/OffOnAssert read high
When On, write is asserted high.On/OffOnAssert write high
When On, byteenable is asserted high.On/OffOnAssert byteenable high
When On, readdatavalid is asserted high.On/OffOnAssert readdatavalid
high
When On, arbiterlock is asserted high.On/OffOnAssert arbiterlock high
When On, lock is asserted high.On/OffOnAssert lock high
Burst Attributes
When On, the address for bursts wraps instead of
incrementing. With a wrapping burst, when the address
reaches a burst boundary, it wraps back to the previous
burst boundary. Consequently, only the low order bits
are used for addressing.
On/OffOnLinewrap burst
When On, memory bursts are aligned to the address size.On/OffOnBurst on burst
boundaries only
Miscellaneous
The maximum number of pending reads that can be
queued by the slave.
N/A1Maximum pending
reads
Sets the read latency for fixed-latency slaves. Not used on
interfaces that include the readdatavalid signal.
N/A1Fixed read latency
(cycles)
For VHDL BFMs only. Use this option to assign a unique
number to each BFM in the testbench design.
0–10230VHDL BFM ID
Timing
For master interfaces that do not use the waitrequest
signal. The read wait time indicates the number of cycles
before the master responds to a read. The timing is as if
the master asserted waitrequest for this number of
cycles.
N/A1Fixed read wait time
(cycles)
For master interfaces that do not use the waitrequest
signal. The write wait time indicates the number of cycles
before the master accepts a write.
N/A0Fixed write wait time
(cycles)
Avalon-MM Master BFM
Altera Corporation
Send Feedback
Parameters
5-8
Commenti su questo manuale