
This mode is expressed in the following equation.
The following shows the pre-adder square mode of two multipliers.
Figure 9-5: Pre-adder Square Mode
a0
b0
a1
b1
Mult0
Mult1
result
+/-
+/-
Pre-adder Constant Mode
In this mode, one multiplier operand derives from the input port, and the other operand derives from the
internal coefficient storage. The coefficient storage allows up to 8 preset constants. The coefficient
selection signals are coefsel[0..3].
The following settings are applied in this mode:
• The width of the dataa[] input (WIDTH_A) must be less than or equals to 27 bits
• The width of the coefficient input must be less than or equals to 27 bits
• The datab[] port must be disconnected
This mode is expressed in the following equation.
The following figure shows the pre-adder constant mode of a multiplier.
Figure 9-6: Pre-adder Constant Mode
a0
Mult0
result
coef
coefsel0
9-6
Pre-adder Constant Mode
UG-01063
2014.12.19
Altera Corporation
ALTMULT_ADD (Multiply-Adder)
Send Feedback
Commenti su questo manuale