Altera Video and Image Processing Suite Manuale Utente Pagina 64
- Pagina / 310
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Interrupts
The CVI IP cores produce a single interrupt line.
Table 4-5: Internal Interrupts
The table below lists the internal interrupts of the interrupt line.
IP Core Internal Interrupts Description
Clocked Video Input IP core
Status update interrupt Triggers when a change of resolution in the
incoming video is detected.
Stable video interrupt
• Triggers when the incoming video is
detected as stable (has a consistent sample
length in two of the last three lines) or
unstable (if, for example, the video cable is
removed).
• The incoming video is always detected as
unstable when the vid_locked signal is
low.
Clocked Video Input II IP core
Status update interrupt Triggers when the stable bit, the vid locked
bit or the resolution valid bit of the Status
register changes value.
End of field/frame
interrupt
• If the synchronization settings are set to
Any field first, triggers on the falling edge
of the v sync.
• If the synchronization settings are set to
F1 first, triggers on the falling edge of the
F1 v sync.
• If the synchronization settings are set to
F0 first, you can use the interrupt to
trigger the reading of the ancillary packets
from the control interface before they are
overwritten by the next frame.
These interrupts can be independently enabled using bits [2:1] of the Control register. Their values can be
read using bits [2:1] of the Interrupt register. Writing 1 to either of these bits clears the respective
interrupt.
Clocked Video Output Video Modes
The video frame is described using the mode registers that are accessed through the Avalon-MM control
port.
If you turn off Use control port in the parameter editor for the CVO IP cores, then the output video
format always has the format specified in the parameter editor.
UG-VIPSUITE
2015.05.04
Interrupts
4-5
Clocked Video Interface IP Cores
Altera Corporation
Send Feedback
- 101 Innovation Drive 1
- San Jose, CA 95134 1
- Contents 2
- Feature Support 7
- Release Information 9
- Device Family Support 10
- IP Core Mode Latency 11
- Interfaces 28
- Video Formats 29
- D0 D1vid_data 32
- Signal Name Description 33
- Avalon-ST Video Protocol 34
- Video Data Packets 38
- Symbol transmitted first 39
- Symbol transmitted last 39
- Plane for even rows 40
- Plane for odd rows 40
- Control Data Packets 42
- Parameters 43
- Description 43
- Type Width Height Interlacin 43
- Order Symbol Order Symbol 45
- Ancillary Data Packets 46
- Packet Propagation 46
- Parameter Name Value 47
- Signal Width Direction 47
- Packet Transfer Examples 48
- Parameter Value 50
- Avalon-MM Slave Interfaces 52
- Avalon-MM Master Interfaces 55
- Related Information 56
- Getting Started 57
- OpenCore Plus IP Evaluation 59
- Control Port 60
- Format Description 61
- Interrupts 64
- Generator Lock 68
- Underflow and Overflow 70
- Timing Constraints 71
- Handling Ancillary Packets 71
- Modules Description 75
- Address Register Description 100
- UG-VIPSUITE 105
- 2015.05.04 105
- 2D FIR Filter IP Core 106
- Coefficient Precision 107
- Parameter Value Description 108
- 2D FIR Filter Signals 109
- Signal Direction Description 110
- Video Mixing IP Cores 112
- Alpha Blending 113
- Video Mixing Signals 116
- 20 Input 3 enable 121
- Chroma Resampler IP Core 122
- 4:4:4 to 4:2:2 123
- 4:2:2 to 4:4:4 123
- Vertical Resampling (4:2:0) 124
- Chroma Resampler Signals 126
- Video Clipping IP Cores 127
- Video Clipping Signals 130
- Color Plane Sequencer IP Core 135
- Rearranging Color Patterns 136
- Splitting and Duplicating 137
- Subsampled Data 138
- Color Plane Sequencer Signals 139
- IP Cores Feature 141
- Input and Output Data Types 142
- Color Space Conversion 142
- Operands 145
- Control Synchronizer IP Core 153
- Control Synchronizer Signals 157
- Deinterlacing IP Cores 160
- Deinterlacing Methods 161
- Bob with Scanline Duplication 162
- Motion-Adaptive 162
- Sobel-Based HQ Mode 164
- Frame Buffering 165
- Types Description 166
- Frame Rate Conversion 167
- Altera Corporation 168
- Send Feedback 168
- Deinterlacing Signals 176
- Register Address 190
- (Decimal) 190
- Register Suggested 190
- Settings 190
- Comments 190
- Tuning Motion Shift 191
- Frame Reader IP Core 192
- Frame Reader Signals 194
- Frame Buffer IP Cores 198
- Double Buffering 199
- Triple Buffering 199
- Locked Frame Rate Conversion 200
- Color Format 201
- Frame Buffer Signals 206
- Gamma Corrector IP Core 214
- Gamma Corrector Signals 215
- Interlacer IP Core 218
- Interlacer Parameter Settings 219
- Interlacer Signals 219
- Interlacer Control Registers 221
- Scaler II IP Core 222
- Bilinear Algorithm 223
- Double-Buffering 226
- Scaler II Parameter Settings 230
- Scaler II Signals 233
- Scaler II Control Registers 235
- Video Switching IP Cores 237
- Mixer Layer Switching 238
- Video Switching Signals 239
- Test Pattern 243
- Trace System IP Core 253
- Trace System Signals 255
- Trace Within System Console 258
- TCL Shell Commands 259
- Command Arguments Function 260
- Packet Visualization 263
- Monitor Settings 264
- Subscribe 269
- Avalon-ST Video Class Library 270
- Class Description 272
- Running the Tests 275
- Video File Reader Test 278
- Example Test Environment 281
- Video Field Life Cycle 282
- Constrained Random Test 283
- Code for Scoreboards 285
- Code for to_grey Function 286
- Complete Class Reference 287
- Method Call Description 288
- Member Description 288
- Raw Video Data Format 299
- Y 410 / A 2R 10 G 10 B 10 301
- Additional Information 306
- Date Version Changes 307
- How to Contact Altera 310
Prodotti e manuali riguardandi Strumenti di misura Altera Video and Image Processing Suite
(24 pagine)© 2020, manymanuals.it. Tutti i diritti riservati | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale