
4–4 Chapter 4: Development Board Setup
Factory Default Switch Settings
Stratix IV GX FPGA Development Kit User Guide March 2014 Altera Corporation
4. Set DIP switch bank (SW5) to match Table 4–3 and Figure 4–2.
3 LCD_PWRMON
Switch 3 has the following options:
■ When on, the LCD is driven from the MAX II device.
■ When off, the LCD is driven from the FPGA.
On
4 FAN_FORCE_ON
Switch 4 has the following options:
■ When on, the fan is forced on.
■ When off, the fan speed is controlled by the MAX1619 device.
Off
5 CLK_SEL
Switch 5 has the following options:
■ When on, the 100 MHz oscillator input is selected.
■ When off, the SMA input is selected.
On
6 CLK_ENABLE
Switch 6 has the following options:
■ When on, the on-board oscillator is enabled.
■ When off, the on-board oscillator is disabled.
On
7 S4VCCH_SEL
Switch 7 has the following options:
■ When on, 1.4 V is selected.
■ When off, reserved.
On
8 S4VCCA_SEL
Switch 8 has the following options:
■ When on, 3.3 V is selected.
■ When off, 2.5 V is selected.
On
Table 4–2. SW4 Dip Switch Settings (Part 2 of 2)
Switch
Board
Label
Function
Default
Position
Table 4–3. SW5 Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1 PCIE_PRSNT2n_x1
Switch 1 has the following options:
■ When on, x1 presence detect is enabled.
■ When off, x1 presence detect is disabled.
Off
2 PCIE_PRSNT2n_x4
Switch 2 has the following options:
■ When on, x4 presence detect is enabled.
■ When off, x4 presence detect is disabled.
Off
3 PCIE_PRSNT2n_x8
Switch 3 has the following options:
■ When on, x8 presence detect is enabled.
■ When off, x8 presence detect is disabled.
Off
4 MAX_EN
Switch 4 has the following options:
■ When on, reserved.
■ When off, reserved.
Off
Commenti su questo manuale