Figure 17: Erasing Memory in a Specified Die
This figure shows an example of the latency when the Altera ASMI Parallel IP core is executing the erase
memory command. The latency shown does not correctly reflect the true processing time. It shows the
command only.
The IP core registers the die_erase signal on the rising edge of the clkin signal. The address placed on
the addr[31..0] signal is a valid address in the die that you can erase.
Ensure that the memory address to be erased appears on the addr[31..0] signal before setting the wren
and die_erase signals to a value of one. After the IP core receives the die erase command, the IP core
asserts the busy signal when erasing the die.
If wren signal has a value of zero, then the die erase operation is carried out, and the busy signal remains
deasserted.
If the memory region is protected (specified in the EPCQ-L status register), the erase operation cannot
proceed, and the busy signal is deasserted. The illegal_erase port is then asserted for two clock cycles
to indicate that the erase operation has been cancelled.
If you keep the wren and die_erase signals asserted while the busy signal is deasserted after the IP core
has finished erasing the memory, the IP core re-registers the wren and die_erase signals as a value of one
and carries out another die erase operation. Therefore, before the IP core deasserts the busy signal, you
must deassert the wren and die_erase signals.
Enable 4-byte Addressing Operation for an EPCQ256/EPCQ-L256 or Larger Devices
The en4b_addr input port allows you to access all memory address of an EPCQ256/EPCQ-L256 or larger
devices. These input ports are available when you use an EPCQ256/EPCQ-L256 or larger devices.
Note:
The 4-byte addressing operation is supported for EPCQ256/EPCQ-L256 or larger devices only, so
you must enable 4-byte addressing when you use an EPCQ256/EPCQ-L256 or larger devices.
To enable 4-byte addressing mode, pull the write enable signal (wren) high, followed by the en4b_addr
signal for at least one clock cycle. If the wren signal has a value of zero, the 4-byte addressing operation
will not be carried out even though the en4b_addr signal is being pulled to high. After the IP core receives
the 4-byte addressing command, the IP core asserts the busy signal to indicate the operation is in
progress.
UG-ALT1005
2014.12.15
Enable 4-byte Addressing Operation for an EPCQ256/EPCQ-L256 or Larger Devices
33
Altera ASMI Parallel IP Core User Guide
Altera Corporation
Send Feedback
(11 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale