Altera USB-Blaster II Manuale Utente Scaricare il pdf (Pagina 5)

October 2014 Altera Corporation USB-Blaster II Download Cable

User Guide

1. Setting Up the USB-Blaster II Download

Cable

The USB-Blaster™ II download cable interfaces a USB port on a host computer to an

Altera

FPGA mounted on a printed circuit board. The download cable sends data

from the PC to a standard 10-pin header connected to the FPGA. You can use the

download cable for the following:

■ Iteratively download configuration data to a system during prototyping

■ Program data into the system during production

■ Advanced Encryption Standard (AES) key and fuse programming

Supported Devices and Systems

You can use the USB-Blaster II download cable to download configuration data to the

following Altera devices:

■ Stratix

series FPGAs

■ Cyclone

series FPGAs

■ MAX

series CPLDs

■ Arria

series FPGAs

You can perform in-system programming of the following devices:

■ EPC4, EPC8, and EPC16 enhanced configuration devices

■ EPCS1, EPCS4, EPCS16, EPCS64, and EPCS/Q128, EPCQ256, and EPCQ512 serial

configuration devices

The download cable supports target systems using the following:

■ 5.0-V TTL, 3.3-V LVTTL/LVCMOS

■ Single-ended I/O standards from 1.5 V to 3.3 V

Power Source Requirements

■ 5.0 V from the USB cable

■ Between 1.5 V and 5.0 V from the target circuit board

Software Requirements and Support

■ Windows 7/8 (32-bit and 64-bit)

■ Windows XP (32-bit and 64-bit)

■ Windows Server 2008 R2 (64-bit)

■ Linux platforms such as Red Hat Enterprise 5

Use the Quartus

II software version 14.0 or later to configure your device.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Nessun commento

Altera USB-Blaster II Manuale Utente Pagina 5