Altera MAX 10 FPGA Manuale Utente Scaricare il pdf (Pagina 14)

3–2 Chapter 3: Board Components

Board Overview

MAX 10 FPGA (10M08S, 144-EQFP) Evaluation Kit October 2014 Altera Corporation

User Guide

Table 3–1. MAX 10 FPGA (10M08S, 144-EQFP) Evaluation Kit Components

Board Reference Type Description

Featured Device

U2 FPGA

10M08SAE144C8G, (or ES variant) Plastic Enhanced Quad Flat Pack

(EQFP), 144 pins, 22 mm x 22 mm.

For package details, refer to the Altera Device Package Information

page.

Configuration, Status, and Setup Elements

Jumper for analog input

channel #8

Default connection is to GND. Change jumper to pins 1 and 2 to switch

analog source to Arduino header.

Jumper for analog input

channel #7

Default connection is to potentiometer (customer option to purchase

and install). Change jumper to pins 1 and 2 to switch analog source to

Arduino header.

SW3

User-defined DIP switch 6-position switch. SW3.1 through SW3.5 are user-defined. SW3.6 is

predefined for dual-image configuration.

D1, D2, D3, D4,

LED, red These LEDs cycle off and on when the kit is powered on.

D6 Power LED, green Illuminates when USB power is present.

SW2

FPGA reconfiguration push-

button

Toggling this button causes the FPGA to reconfigure from on-die

Configuration Flash Memory (CFM).

Clock Circuitry

X1 50-MHz oscillator 50-MHz crystal oscillator for general purpose logic.

General User Input and Output

D1, D2, D3, D4,

User-defined LEDs, red User-defined LEDs.

SW1 FPGA register push-button Toggling this button resets all registers in the FPGA.

R94 Potentiometer

You must purchase and install this device to provide analog inputs

signals to the MAX 10 ADC IP block (analog input channel 8).

Connectors

J2, J3, J4, J5 Arduino UNO R3 connectors

You can purchase Arduino Uno R3 compatible Shields (i.e.

daughtercards) to connect to the Arduino headers installed on the

board.

J10 JTAG header

Connects an Altera USB-Blaster, USB-Blaster II, or Ethernet Blaster to

program or configure the FPGA.

— Prototype Area

This through-hole area is not connected to the FPGA. You can use this

area to connect or solder additional components.

Power Supply

J1 USB connector Connects a USB cable to a power source.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Commenti su questo manuale

Nessun commento

Altera MAX 10 FPGA Manuale Utente Pagina 14

Commenti su questo manuale

Prodotti e manuali riguardandi Strumenti di misura Altera MAX 10 FPGA