Altera Arria V GT FPGA Manuale Utente Scaricare il pdf (Pagina 55)

Appendix A: Programming the Flash Memory Device A–5

Restoring the MAX II CPLD to the Factory Settings

November 2012 Altera Corporation Arria V GT FPGA Development Kit

User Guide

1 Because two FPGA devices are hard wired in the JTAG chain, and it is possible to

configure Nios II CPU devices on both FPGAs simultaneously,

nios2-flash-programmer commands may require the

--device=<device index>

and

--instance=<instance>

arguments.

f For more information about the nios2-flash-programmer utility, refer to the Nios II

Flash Programmer User Guide. To ensure that you have the most up-to-date factory

restore files and information about this product, refer to the Arria V GT FPGA

Development Kit page of the Altera website.

Restoring the MAX II CPLD to the Factory Settings

This section describes how to restore the original factory contents to the MAX II CPLD

on the FPGA development board. Make sure you have the Nios II EDS installed, and

perform the following instructions:

1. Set the board switches to the factory default settings described in “Factory Default

Switch and Jumper Settings” on page 4–2.

2. Launch the Quartus II Programmer.

3. Click Auto Detect.

4. Click Add File and select <install

dir>\kits\arriaVGT_5agtfd7kf40_fpga\factory_recovery\max2.pof.

5. Turn on the Program/Configure option for the added file.

6. Click Start to download the selected configuration file to the MAX II CPLD.

Configuration is complete when the progress bar reaches 100%.

f To ensure that you have the most up-to-date factory restore files and information

about this product, refer to the Arria V GT FPGA Development Kit page of the Altera

website.

1 2 ... 50 51 52 53 54 55 56 57 58

Nessun commento

Altera Arria V GT FPGA Manuale Utente Pagina 55