Altera Transceiver Signal Integrity Manuale Utente Scaricare il pdf (Pagina 19)

Chapter 6: Stratix IV GT Transceiver Signal Integrity Demonstration 6–3

Running the Demonstration Application and Test Designs

December 2014 Altera Corporation Transceiver Signal Integrity Development Kit,

Stratix IV GT Edition User Guide

1 Because the demonstration application communicates with the board using the same

interface as the Quartus II Programmer or SignalTap

II Embedded Logic Analyzer,

you can run only one of these applications at a time.

1 The application will not run unless the USB cable is attached, power is applied, and

the correct .sof is programmed to the Stratix IV GT FPGA as specified in Table 6–1 on

page 6–1.

c For operating system stability, keep the USB cable connected and the board

powered ON when running the demonstration application.

Demonstration Application Description

The demonstration application provides an easy-to-use interface (Figure 6–1) to

change transceiver parameters and observe the performance. You can customize your

board design by choosing transceiver settings from the categories described in this

section.

Figure 6–1. Demonstration Application Control Panel Window

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Nessun commento

Altera Transceiver Signal Integrity Manuale Utente Pagina 19