Altera Stratix III Manuale Utente Scaricare il pdf (Pagina 15)

4. Development Board Setup

Introduction

The instructions in this chapter explain how to install the development board and

configure the FPGA.

Requirements

Before starting the installation, verify that you have complied with the conditions

described in “Hardware Requirements” on page 2–3 and have completed the

following requirements:

■ Quartus II software installed on the host computer

■ USB-Blaster driver software installed on the host computer.

1 The Stratix III development board includes integrated USB-Blaster circuitry for FPGA

programming. Host computer and development board cannot communicate without

the USB-Blaster driver software installed. For installation information, refer to

“Installing the USB-Blaster Driver” on page 3–3.

Powering Up the Board

Figure 4–1 shows the Stratix III development board and its components.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Nessun commento

Altera Stratix III Manuale Utente Pagina 15